Flush and surface mount spike barrier in Cape Town

Emergency Trigger Inputs – 2 Types

• Spike will raise boom; boom will close while loop is detecting, spike will raise even if boom arm is in the up position.
• Spike will raise; boom will close after the loops has been cleared, spikes will raise even if boom arm is in the up position.
• Built in robot controller for dual direction.
• Robot will turn green for right of way and red for opposite traffic.
• Robot stays red if tailgating occurs.

• The surface mount scorpion spike barrier is designed for under cover parking where a flush mount spike barrier cannot be installed.
• It is also designed to be installed in a clean environment where dirt and debris cannot be flushed into the spike tray.

• New control panel allows for interlocking with other barrier to create a trap barrier.
• Spikes will stay up when boom arm is forced open.
• Spike barrier can be used for reversible lanes.
• Spike barrier will go into a lock down mode when the door is opened.
• Service indicator light will light up when the spike barrier needs to be serviced – Self diagnostic logic controller.
• Optional extra: High security lock – tamper proof door.
• Optional extra: Spring device to lower spike during power failure.

Alarm outputs, 1 sec n/o pulse output and a permanent close output.

• When boom arm has been knocked off the adaptor – permanent close output.
• When the barrier door is opened – permanent close output.
• When boom is held open after a vehicle has passed over the loop – pulse output.
• When boom arm is forced open – pulse output.
• When the spikes are held down – pulse output.

This can be used to trigger an alarm. Switch a camera to focus on the spike barrier. It can also be used to raise the spikes by means of an internal triggering device or alert armed response.

• To allow emergency evacuation from the premises.
• To allow emergency vehicles into premises in case of an emergency.

• The “Road spike” barrier is available in either 3m or 5m options standard. Custom size units can be accommodated. Prices available on request.
• Barrier boom arms are manufactured extruded aluminum tubing powder coated in white with red reflective tape.
• The barrier is equipped as standard with an anti-pedestrian aluminum curtain suspended beneath the boom arm to prevent personal injury.
• Left and right hand configurations are available.
• The spikes lower before the boom arm opens. This ensures a safe passage for the vehicle to pass through. The boom arm can’t open unless the spikes have lowered completely by means of an inter-lock.
• The spike barrier can be interfaced with single or multiple remote triggering devices.
• The spike barrier framework is designed to handle commercial vehicles and buses – but not recommended for big trucks.
• The cabinet is a IP54 rated enclosure, 1.6mm mild steel or 3CR12 stainless steel or 2mm 304 brushed stainless steel.
• Cabinets are powder coated in red and white but any RAL colours are available on request.
• The spikes protrude 90mm above the spike tray and offers protection from both directions.
• The “Road spike” barrier’s modular design allows the unit to be stripped down to small manageable sizes for easy transportation and installation.
• Pack size: Dependent on model ordered.
• Mains supply: 220V at 130 watts with no robots and 205 watts with robots.